Mutation X RDA is an atomizer that those on tight budget can have if they want to still enjoy blowing big clouds. It is a uniquely design atomizer from Indulgence. Mutation X is seriously about air flow.
Mutation X RDA Air Flow
Cloud production is affected by several components. One is vaping with high VG ratio ejuice. Sub-ohm vaping at 0.2 ohm and below is an extreme vaping that can produce massive clouds. With sub-ohm builds, air flow is also critical because the vapor can really become so hot. Aid is required to cool down the unit to a reasonable vape temperature.
Not all low end RDAs are made for chucking out clouds of vapor. This is because not all of them are safe to use for this purpose. However, pairing Mutation X with the perfect battery will allow you to experiment on big clouds without worrying so much about safety.
Design and Build
Mutation X has 3 sections. It has the usual deck, sleeve and to cap configuration. Its deck posts have big lead holes so you will not have trouble using thicker low resistance wires. The negative posts are of the deck so you can achieve maximum connectivity. Mutation X promises a nice and hard hit. The deck is also deep that you can vape with a lot of juice.
Mutation X has a pretty 9-hole air flow control that sits in groups of 3. Massive clouds can be achieved when the coil is centered on the deck in the middle row so air will come from all angles. There are two covers on the top cap that allows controlling of which holes will be open.
The top cap also has the fin design similar with the Tobh Atty and also the Vulcan RDA. This fin serves as heat sink for keeping the drip tip from retaining any heat.
A drawback of Mutation X is that it supports quad coil or dual coil setups. It is not particularly built for sub-ohm builds. Although not made for such, Mutation X will certainly let you blow clouds and fog your home. This RDA has 22 mm RDA also it will look good on any 22 mm battery or mod.
Another Budget Friendly RDA
Mutation X is an RDA that will allow you to enjoy vapor clouds without really breaking the bank. It is very important that you practice safety measures when building coils and preparing your setup. While you can get skimpy on your RDA, be sure that you do not cut your budget short on batteries.
In case you want to have another option for a budget-friendly RDA, get a Storm RDA V2. This new model came out just months after the first Storm-A by Orieco was released and made a huge wave.
Storm-A has been quite impressive that it incorporated the design elements that are usually found in RDAs well above the $100 mark into a unit that is only a fraction of this cost. V2 simply is the improvement of the original design.
Also at $24.99, there are three sections that make up V2: one post and 2 screws. There are likewise 2 big juice wells on the sides of the deck. The other remaining sections are the airflow control ring and the top cap.
The deck section of V2 is taller than that of A. The wells are also slightly rounded and almost double the size of ejuice that can be dripped. The top cap is likewise taller to compensate for the deeper wells. The interior of the top cap has been redesigned. This creates a conical funnel where the vapor can be channel all the way out of the RDA. This is the same design as other high end RDAs like magma and Tobh. With this, a spinning motion is created as you pull the air through the device. It offers a smoother pull and a denser vape.